- whatsapp +51955515985
- support@ecuforcetruck.com
- 24/7 Customer Support
Menu
Shop
Account
Subtotal: $0.00
No products in the cart.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6432 PID: SPN: 641 FMI: 14 VGT Actuator Controller – Out of Calibration. The VGT actuator has been installed incorrectly.
Circuit Description
The variable geometry turbocharger (VGT) is electronically activated by the VGT actuator. The VGT actuator is a smart device and receives information via the J1939 data link from the primary engine control module (ECM). The VGT actuator performs its own diagnostics and reports malfunctions back to the primary engine ECM, using the J1939 data link. The ECM then decodes the error message and converts it to a fault code.
Component Location
The VGT actuator is located on the turbocharger bearing housing.
Conditions for Running the Diagnostics
1)This diagnostic runs when the keyswitch is initially turned to the ON position.
2)The keyswitch must be turned OFF for more than 30 seconds before this diagnostic will run at initial key ON.
Conditions for Setting the Fault Codes
The Variable Geometry Turbocharger (VGT) actuator position was not known during initial power ON.
Action Taken When the Fault Code is Active
1)The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
2)VGT actuation will be disabled.
3)Exhaust Gas Recirculation (EGR) valve operation will be disabled.
4)Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, and leave the keyswitch in the ON position for 1 minute. Note that the keyswitch must be completely turned OFF for more than 30 seconds before this diagnostic will run at initial key ON.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Shop Talk
This fault code can only be logged after the VGT actuator has been removed or replaced, and then not installed correctly. The gear alignment between the actuator and the turbocharger housing is misaligned. The correct installation procedure must be followed when replacing the VGT actuator.
Related
Categories Cumminz, ISB6.7 CM2350 (2013-17)Tags 14, 17, 2013, 641, 6432, Actuator, been, Calibration, CM2350, Code, Controller, Cummins, Fault, FMI, has, incorrectly., installed, ISB6.7, of, Out, PID, SPN, the, VGT
Wiring Diagrams
Component Locators
- Detroit Diesel Diagnostic Link DDDL 8.0 PRO PROFESSIONAL Software trucks
Detroit$25.00
Rated 0 out of 5
- download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi$76.00
Rated 0 out of 5
- NAVISTAR ENGINE CYLINDER PERFORMANCE ANALYZER V7.8.8.1
Navistar$52.00
Rated 0 out of 5
- Wabco PIN Code Calculator Diagnostic Software PIN 1 PIN 2
Trucks software$10.00
Rated 0 out of 5
- CAT ET Electronic Technician 2018C
CAT$45.00
Rated 0 out of 5
- Detroit Diagnostic Link (DDDL 8.09) Engineering level 10
Detroit$40.00
Rated 0 out of 5
- Allison DOC 2021 V2 (1PC)
Allison$67.00
Rated 0 out of 5
- Navistar international OnCommand service information 2018 software trucks
Navistar$50.00
Rated 0 out of 5
- JCB ServiceMaster 4 v21.4.2 [05.2021] Diagnostic Software
JCB$85.00
Rated 0 out of 5
- VOLVO PROSIS 2023 ( 11.2022 )
Trucks software$96.00
Rated 0 out of 5
- JPRO 2022 v3 ( 1 PC )
JPRO$94.00
Rated 0 out of 5
- DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software 1PC
DOOSAN$106.00
Rated 0 out of 5
NISSAN UD$100.00
Rated 0 out of 5
- download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )
MAN$75.00
Rated 0 out of 5
- Bendix 6.16 ACom Diagnostics ( bendix software trucks )
Bendix$35.00
Rated 0 out of 5
- Diagnostic Software for Navistar Diamond Logic Builder 2023 (DLB)
Navistar$94.00
Rated 0 out of 5
- Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software$143.00
Rated 0 out of 5
- VOLVO PTT TECH TOOL 2.8.220 2023 Last version 1pc
Trucks software$200.00
Rated 0 out of 5
John Deere$120.00
Rated 0 out of 5
- Hino Diagnostic eXplorer 2 – Hino DX2 v1.1.21.4 with keygen unlocked ( Hino trucks )
Hino$60.00
Rated 0 out of 5
Related products
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3256 PID: SPN:3246 FMI:0 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3258 PID: SPN:4340 FMI:5 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 1 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:324 PID:SID 3 SPN:653 FMI:5 Injector Solenoid Driver Cylinder 3 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3315 PID: SPN:4765 FMI:2 Aftertreatment 1 Diesel Oxidation Catalyst Intake Temperature – Data Erratic, Intermittent, or Incorrect
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3251 PID:S326 SPN:4765 FMI:0 Aftertreatment Diesel Oxidation Catalyst Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:331 PID:SID 2 SPN:652 FMI:5 Injector Solenoid Driver Cylinder 2 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3261 PID:SID 254 SPN:4342 FMI:5 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3254 PID: SPN:3242 FMI:0 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3241 PID: SPN:4342 FMI:4 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Voltage Below Normal or Shorted to Low Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3231 PID: SPN:4360 FMI:16 Aftertreatment SCR Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3232 PID: SPN:3216 FMI:9 Aftertreatment 1 Intake NOx Sensor – Abnormal Update Rate
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3254 PID: SPN:3242 FMI:15 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:332 PID:SID 4 SPN:654 FMI:5 Injector Solenoid Driver Cylinder 4 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3255 PID: SPN:3246 FMI:0 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3256 PID: SPN:3246 FMI:15 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 953 sms
BOBCAT$40.00
Rated 0 out of 5
- SERVICE MANUAL MACK E7
MACK$27.00
Rated 0 out of 5
FUSO$43.00
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 220 sms
BOBCAT$60.00
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 2000 sms
BOBCAT$30.00
Rated 0 out of 5
- MANUAL SERVICE DEUTZ AGROTRON 80-85-90-100-105 MK3
DEUTZ$32.00
Rated 0 out of 5
- SERVICE MANUAL Input and Output Configurations Allison Transmission
Allison$21.00
Rated 0 out of 5
- SERVICE MANUAL International Engines MaxxForce 15
INTERNATIONAL ENGINES$40.00
Rated 0 out of 5
- SERVICE MANUAL BOBCAT 620 sms
BOBCAT$47.00
Rated 0 out of 5
- SERVICE MANUAL Mack MP8-Euro3
MACK$27.00
Rated 0 out of 5